The model 9530 and 9550 operators are designed to operate very
heavy vehicular slide gates in limited (Class III) and restricted (Class
IV) applications only. These operators should never be used in
applications serving the general public. These operators are designed
so that they can easily be mounted in the front, center or rear of the
gate without any costly and time consuming field modifications. These
operators include a speed control module which allows the user to set
the speed of the gate from 1/2 to 2 feet/sec. in the model 9530; and 1/2
tp 4 feet/sec in the model 9550. Each of these operators have a
slow-start and slow-stop function as well. Additionally, an emergency
close input (model 9530 only) increases the gate speed up to 6 Ft./sec
in the closing cycle.
*Speed control module.
*Slow start / slow stop.
*Emergency close (9530 only).
*Direct driven limit nuts.
*Gate tracker reporting output.
*Ports for plug-in loop detectors.
*Two convenience outlets.
*Fail-secure operation includes crank for manual operation.
*Built-in reset switch.
*Built-in power On/Off switch.
*Maximum gate length 160-feet.
*Maximum gate weight 10,000 pounds*. (*Assumes gate is on
level ground, in good condition with properly adjusted hardware. Other
external factors may affect the performance of the gate operator.)
*Adjustable gate speed: 1/2 - 4 Ft./sec.
*10:1 gear reduction running in a continuous oil bath.
*Self adjusting disc brake with manual release.
*5 HP continuous-duty motor.
*208, 230 VAC three-phase only.
*Operator is shipped with chain brackets and 20-feet of #60 chain.
*Class III and IV applications only.
*Compliant with UL 325 and 991 - but not yet listed. (Note: To
be compliant with UL 325 and industry safety guidelines, a secondary
entrapment prevention device(s) is required to be installed with this
*Dimensions: 50 "W x 56 "H x 28 "D
*LIST PRICE: $21,480.00